Translogic dash 1.0

[Baddie]

Hello wiring Guru’s

Id likes to pick your brain if possible.

Just over two weeks ago one of my lovely daughters had left my ignition on my bike and ever since I recharged my near death battery my Translogic dash is playing silly buggers.

Below is a recent video of what is currently going on…

You will see once the a gear is selected and the clutch released both Speedo and Km reading is running off this planet.

http://www.youtube.com/watch?v=VyUo1...ature=youtu.be

Today I removed just about 10kms of tape to suss out the wiring but I also re-installed OEM dash (below).

Issue18 Manual pages 1-4.pdf



Uploaded with ImageShack.us


Once I re-installed dash I started the bike and the OEM unit worked fine both speedo , tacho and Km reading worked as came out of the factory.

Below is how I attached translogic wiring harness the OEm harness.



Uploaded with ImageShack.us

Here is a picture of how the OEM dash wiring that connects to my OEM dash, can I ask which one you think is the “Ground (Negative)” as current I have both black wires from both harness connected to the Green /Black wire.



Uploaded with ImageShack.us

Thanks in advance.

[Baddie]

Sorry rick...Ill ring you tomorrow...misses dragged my chrissy shopping, hence no time to chat.