I've been spending some time on my exhaust today. It's been a little neglected since I dropped the bike on T3 a while back.
It ended up pretty squished, but as the bike is tuned to the full Ti Over Racing system, I didn't really want to swap it out.

The first recovery step was to jam the whole thing in a vice and slowly crank it up. Like a tyre going on a rim, a few POP's later and it was pretty well back to shape.
Next I drilled out the rivets holding on the end cap and rotated the end and internals round by 180 degrees.
Although the system was a limited edition run, for R6, I was able to track down a new metal emblem from Japan for $25.




After getting rid of the gravel rash with some emery paper and metal polish, I riveted it all back together and here it is: